Jusgunn3's latest activity
-
JFor sale is my Mastermind 592xp. It's a big, well ported saw and performs as such. I've ran it with echo red armor at 40:1 with...
-
JJusgunn3 replied to the thread Saw builders chime in..I want one as well, have a 543xp that is going to get messaged by @huskihl but have heard its not as impressive as the 242xp…I guess I...
-
JGenerally speaking … Quads can give better flow , efficiency, scavenging and most importantly more power at “in the cut” rpm but are...
-
JDang. Gotta get a 242xp now.
-
JStihl splits the uppers, Husky doesn’t. Is one better?
-
JI don’t think it’s necessarily the quads that make more power, it’s the path of the air. The entire 5 series runs pretty decent with...
-
JIf quads are so much better why are many modern units duals?
-
JI gained 1500+ rpms in the cut by switching from a stock flocked 026 filter to a fine mesh 260 pro filter. I had to modify my top cover...
-
JJusgunn3 reacted to singinwoodwackr's post in the thread The Husky 42/42 special/242/246 thread with
Like.
Got my 246 all stripped down and cleaned, case mag rot repaired and case halves painted. Just need to reassemble. -
JJusgunn3 reacted to Sloughfoot's post in the thread Not so pros 4 new and without politics or drama with Like.
48 here. Playing winter again with a roaring fire and heat turned off.
-
JJusgunn3 reacted to jacktheripper's post in the thread Not so pros 4 new and without politics or drama with Like.
Just got done building this fence around the new stove to keep our little ones out.
-
JTruth. After porting my 026 it can't get enough air through a stock filter to even begin to accelerate and won't choke well enough to...
-
JI’m with Treemonkey here on the quad vs dual transfer port theory. Perhaps the 550 does have more area when stock but after some work I...
-
JThe lower transfer ports ducts on the 261 appear to be very small. Thr 550xp has much more port area to my eyes.
-
JThe 346 was bad ass back in the day. With that said I bought a 550mk2 when I was in the market for a new 50cc saw. Very smooth, more...