Jusgunn3's latest activity
-
JTruth. After porting my 026 it can't get enough air through a stock filter to even begin to accelerate and won't choke well enough to...
-
JI’m with Treemonkey here on the quad vs dual transfer port theory. Perhaps the 550 does have more area when stock but after some work I...
-
JThe lower transfer ports ducts on the 261 appear to be very small. Thr 550xp has much more port area to my eyes.
-
JThe 346 was bad ass back in the day. With that said I bought a 550mk2 when I was in the market for a new 50cc saw. Very smooth, more...
-
JJonsered 2153 and I'll fückin' fight anyone over it. At least 11% more hp than the orange junk.
-
JThe big unit :
-
J4 pages and nobody has considered the ramifications of the available graphics on the bars that fit each particular model. OPE be slippin..
-
JDon't know if all 4910s are the same or not...
-
JYep, he's from Michigan. Builds them from mild to wild and some very wild! Echo left a lot on the table (jug). They are pretty light and...
-
JThere is a fellow on utube that does wonders with them , tho 🤷 if they would last long in the woods cutting at 14000 rpm in the cut ...
-
JSo, Echo 501P/4910's were mentioned at the start of this hear thread. It has to be said that they need ported to even be considered...
-
JThe dome on oem 026 pistons is relatively slight. On Meteors it's significant. Both come off easy enough.
-
JI never liked how the domed piston affected the porting either. There tons of 026 and 260 out there though. Builder saws are cheap and...
-
J044 parts are getting scarce for sure. Plenty of 026 parts.
