Jusgunn3's latest activity
-
JJusgunn3 reacted to SawAddictedFarmer's post in the thread Husqvarna 450 vs 62cc clone saws with
Like.
I've got my ms362 (59)cc set up with 25" 3/8. It's ok, it's no speed demon but it gets the job done. -
JJusgunn3 replied to the thread The 2025 346xp Porting Thread.I have not but did notice Dukes has the cylinder kits available again.
-
JAnyone try one of these warhawk cylinders recently? Wondering if they are a decent option at all?
-
JHaha I have a 261, although mines not ported 🤔
-
JI don’t really do much milling and not the intention of the 090. Paveen is awesome, I bought a bunch of stuff from him and actually...
-
JTrade you a ported 261 and $$ lol
-
JIf yer head isnt too far up stihl's azshole, sell that silly thing and message pav for a brand new cs 1201p. Bigger crank and piston rod...
-
JWow
-
JI have a new 880 I’m not really sure what to do with? I’ve been tempted to gas it and run it but it wouldn’t really see much use. I...
-
JJusgunn3 reacted to EFSM's post in the thread HELP! Chinese clone chainsaws - worth the hassle ? with Like.
But you don’t have any excuses to upgrade if you can’t wear them out!
-
JJusgunn3 reacted to mainer_in_ak's post in the thread HELP! Chinese clone chainsaws - worth the hassle ? with Like.
China rip-off alternatives: Used grey echo cs 6700, 670, 8000. 67 cc and 81 cc saws that are usually $150-$400 used. Nother cheap one...
-
JJusgunn3 reacted to jacktheripper's post in the thread Not so pros 4 new and without politics or drama with Like.
The threat was sent over email to our admissions office. The sender claimed to be part of a terrorist organization and that bombs would...
-
JJusgunn3 reacted to jacktheripper's post in the thread Not so pros 4 new and without politics or drama with Like.
It most likely is. But I have 7 30 rounders loaded up for the carbine in my truck. You never know what people are up to
-
JJusgunn3 reacted to SimonHS's post in the thread HELP! Chinese clone chainsaws - worth the hassle ? with Like.
Lots of good info in this thread linked below. All the info you need. Good luck reading 164 pages though. In short, most Chinese...
-
JJusgunn3 reacted to Fabulous's post in the thread HELP! Chinese clone chainsaws - worth the hassle ? with Like.
Ok 👍 thanks