Jusgunn3's latest activity
-
JI went through a box of Hammer bullets awhile back. They were accurate as the lead center target bullet I was loading at the time...
-
JLooking to get port work done on my STIHL 462. I reached out to Ripsaw but it’s the older style cylinder and they used to do that by...
-
JCanadian Farmboy is a good porter in Ontario.
-
JI second CFB @Canadian farm boy If you were to ship this to the states, you'd likely have to pay duty on it both ways. The duty-free...
-
JSelling my fine Italian Olympyk 970 that has an efcco 970 tank handle, and a efco 970 starter cover. I have a brand new Oleo Mac...
-
JGet on it! At least 3 of us are waiting to hear! :D
-
JLead free projectiles. I've visited with Steve in the past. Never did try any of there bullets though. Cutting edge out of PA makes a...
-
JBump for a beautiful saw
-
JJusgunn3 replied to the thread What's on your bench?.Since here in the great state I shoot barnes bullets and they do well. I have been wanting to try hammer bullets but have so much Barnes...
-
JSomething I need to get doing as well. Switched powders and need to get a new load developed with the new powder. R26 became hard to...
-
JW1, W2, and W3 for the 357 builds. I’m sure there is a thread somewhere discussing any differences. All measure 0.029” squish without a...
-
JHow were the results? Looking to do this for my NE.
-
JI'm embarrassingly far behind on projects, but I hope to remove the tensioner from my 346xp soon and try them both out.
