jurchybald's latest activity
-
jurchybald replied to the thread 400.1 first impression.Flat top -
jurchybald replied to the thread 400.1 first impression.
-
-
jurchybald replied to the thread 400.1 first impression.I ported one, have two more to do. I did cut the base and than use JB weld to reconstruct that extension back. Went couple of times in...
-
Pretty close to ported 60cc numbers right there. My ms400 (obviously closer to 70cc than 60cc) recipe is 102, 118-120. The intake...
-
Looks like it could be successfully ported right from how it comes without machining.
-
-
So ladies here are to vids from the saw. First stock with cold start. Second with muff mod, carb shafts thinned and oiled foam filter...
-
jurchybald replied to the thread 400.1 first impression.Transfer entrance is way down in the case. Cilinder entrance is just part of a tunnel. That extension on cylinder has to stay there imo
-
-
jurchybald replied to the thread 400.1 first impression.Look at my photo again and imagine how you would cut the base on a lathe. Than add asimetric chamber design and imagine cutting squish...
-
jurchybald replied to the thread 400.1 first impression.It's a PITA saw to work on. You can see everything from this one pic
-
-
Interesting to say the least. Either we figured out what they knew by chance, or they watched the forum.
-
Most of the world doesn't run long bars on 60cc saws. To be honest I never understood why long bars and wrap handle bars were a thing...
