Junk Meister's latest activity
-
JJunk Meister reacted to SawAddictedFarmer's post in the thread Not so pros 4 new and without politics or drama with
Like.
Good morning! Still windy here. -
JJunk Meister reacted to ray benson's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning. 36°F/ 2°C going up to 38°F/3°C. Rain /snow mix moves out by 11am. Shouldn't be much if any accumulation.
-
JIn theory, you could make a base piece that had a cutter mounted. You can definitely modify the cutter for other chamber contours. If...
-
JJunk Meister replied to the thread Stihl 020t wont rev up.Need New batteries in Your Hearing Aids? I am with @Stump Shot with the Gasket DisOrder. One phone call can disrupt the simplest of...
-
JDid you do anything with the metering lever? Does this carburetor have an accelerator plunger?
-
JIs the exhaust gasket blocking the port?
-
JMetering gasket and diaphragm orientation inverted, or improper metering lever height would be possible culprits.
-
JJunk Meister replied to the thread Not so pros 4 new and without politics or drama.Today A slight chance of rain and snow after 5pm. Sunny, with a high near 42. West wind 8 to 17 mph, with gusts as high as 29 mph...
-
JI did not make the squish cutter it is from dyno joe. The rings are interchangeable and can change what size cylinder you want to cut...
-
JJunk Meister replied to the thread What's on your bench?.Main issue i get is these older saws need a muffler or something you might as well do all the gaskets around the cylinder. hard to not...
-
JI have worked on a few of those style (055/075 hybrid, 031) and I am still not a fan. You don't have to worry about me stealing yours! 🤣
-
JHere’s my personal top handle.
-
JHole in the Mattress by Mister Completely. :cool:
-
JJunk Meister replied to the thread sh!t happens.At 20 min in he said the owner has had it for quite a while "ported" never did say by whom..
-
JLooks like early aftermarket with an exploded pin bearing. Some of the early AM jugs had very good porting. It might be worth timing...
