Junk Meister's latest activity
-
JHappy 10th, what a great OPE family.😍😍😍 10 back, just a 55 rancher bone stock. Hope we all meet at 10+ more. ♥️♥️♥️
-
JI'm with you on that. I can understand why Randy got sick of being a moderator, but as a member/poster, he was incredibly valuable. I...
-
JPer Davidwyby: How many saws before you start forgetting which came from where etc...
-
JJunk Meister replied to the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread?.Good MAWNEN Sunday Cloudy, then clearing during the afternoon, with a high near 53. South wind 8 to 16 mph, with gusts as high as 30...
-
JLeft is OK. Put the gap up. The ones on the right will break at the corner of the G
-
JCame with 2 sets
-
JJunk Meister replied to the thread Not so pros 4 new and without politics or drama.Keep them wheelie bearings greased on yer wheelie bin. Might go faster. 😜
-
JJunk Meister reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with
Like.
Good contribution Mr Bilge. This makes a lot of sense. I have a lid-less wheelie bin which has a new purpose in life on the horizon. -
JBike bar tape, lizard skins baseball bat wrap, tennis racket wrap. The latter two won’t last forever but are cheap enough to replace often
-
JI think you will find that the silicone tape is not very durable. You need something on top of it to provide some physical toughness. Mark
-
JI would favor JB Weld, grind or sand (coarse grit) around the hole, JB all around, press in a piece of screen wire and finish with JB...
-
JI would not worry about the tank sealer, generous amounts of JB weld on both sides around the bolt will work fine.
-
JMy junk fund is running low but these were a good deal for the sxs. I can probably sell the wheels to get my $100 back.
-
JJunk Meister replied to the thread Fixing hole in tank.Some shelving like you would see in a parts room (Usually gray) used a 1/4"NC stove bolt with a flat screw driver slot and the head is...
-
JMy first thought was to put the screw back in. Lol
