Junk Meister's latest activity
-
JJunk Meister replied to the thread Chain Tools?.I OOPs, I Stated "Tacomec" I should have Wrote "OREGON". I just went to the BAY but you'll find it in many sites.
-
JTecomec Anvil Pro Chainsaw Saw Chain breaking Repair Tool Replaces Oregon 111939 I have used this type too, works really good.
-
JThanks again, Hacskaroly! These are very helpful posts - especially the words about practicing and going slowly. By the way, the...
-
JJunk Meister replied to the thread Chain Tools?.Tacomec makes an anvil that has an appendage to help hold the tie strap better. 111939 (I like it).
-
J7/16 was very common on many of the earlier direct drive saws. McCulloch supplied it on quite a few models and I have a couple of...
-
JJunk Meister replied to the thread Tell me a joke......Gossip I heard several years ago - Beatrice Nebraska was wanting to write tickets for open TAILGATES on pickups in diagonal parking. No...
-
JJunk Meister replied to the thread Tell me a joke......Truck must be parked over the "KEEP OFF the GRASS" sign.
-
JJunk Meister replied to the thread HELP! Miller welder.I don't weld in the field no where close to the conditions Ya'LL have, but I started using 7018 by the 50# tin in the mid 70's . It...
-
JThere is a big difference between the atom arc rods and the lincoln excaliber-100 out of 100 welders will pick the excaliber rod Try...
-
JBecause there’s really no reason to buy the straight dc version anymore, the ac/dc stuff has been tweaked and runs well on most...
-
JJunk Meister reacted to cus_deluxe's post in the thread Crank bearing installation question with
Like.
im way too impatient to wait the minute or two the heat gun/torch takes. typically i would not heat the case enough, get bearing stuck... -
JYep, I keep a bottle of whatever 2t oil I've gotten with other saws purchases that I don't want to use for mix on the bench and pour a...