Recent content by Joakim S

I see 1 or 2 on Ebay for 53 USD each. Located in the States.

Ok👍🏻. Get it. Yes, I like em as well.

Isn't the elbows possible to buy new from the dealer in the States? 🤔 They are around 7 USD in Sweden. Probably around the same here in Norway.

I see 3 different 394:s in the US and one in Canada. All at Ebay I see now, that one of them is converted into a 395.

Can I ask why you made a casesplit, in the first place? Maybe the rebuild is in another thread? Would be interesting to see.

Great Post, Shaun! Very informative. I will do this operation for my first time very soon, so this was just what I needed

Ok. Good to know. Yes, I've seen on Ebay that the alu prices isn't to bad.

Ok. Do you have any experience of using POM for this kind of work. Sorry for going OT.

Ok. Sounds right. Thanks.

I've been thinking about, if it's possible to use the same mandrel for 2 different cylinders, let's say like in your case, 53mm in one end, and 55mm in the other. Or is is something I haven't thought of?

It looks like they opens at the same time, Bjorn.

Hi:) Nope, I'm not. I will try to check that out in the evening. Thanks:)

Hi again Now I've finally measured my numbers on the new cylinder. Maybe someone could help me which numbers I should aim on, when porting. Like I said before I would like to have a reliable work saw. Hyway cylinder 2071 big bore (2171) Squish 0.65mm. 25,6 thousands. No gasket Outtakeports...

Thanks:). Yes, I hope that to. I might try it again this week.

Ok. So today I've tried out the 3 mins idle and tip in wood. First of all, it was real hard to get started. After a few minutes pulling, it started and could hold the idle for 3 mins. I could hardly hold the tip in the wood, cause than the chain stopped. It didn't work. Shut it of and tried...