JKNW's latest activity
-
The 450 is starting to look a lot nicer. I have been repeatedly washing and scrubbing it to get the caked on crap off. It’s probably the... -
AMC 360 cylinder heads. They were .003" warped. Used a granite surface plate and some 80 grit to surface them and now they're less...
-
In Croatia no one wears Adidas, nor top & bottom track suit sets. PJ lookalike sweatpants with pulled up white socks apparently passes...
-
Echo 9010 blower crankcase. The fan side bearing is a good Japanese NTN but this is the second one I’ve seen with a failed cage. Both...
-
JKNW replied to the thread What's on your bench?.Shrinking an aftermarket 460 3/4 wrap for my 026. 3/4" out of the width, need to drop the top about an inch. Good TIG practice anyway.
-
-
But there’s only a few that understand reality whether it’s now or 1960, i’m pretty sure it was called. Make *s-word happen!!
-
3120’s make my heart go pitter patter. 3 cube race saws are probably my favorite.
-
-
And sometimes just because they're BiG AND RARE. Like a 10 cube 090.
-
Some saws from past decades stand out because they fit their market niche so well. As a result, many of these models are desirable to...
-
JKNW reacted to woodfarmer's post in the thread Firewood thread!!! Let's see what you got!!!! with
Like.
Just started this last week. Some large rounds of red and hard maple. -
JKNW replied to the thread Firewood thread!!! Let's see what you got!!!!.Shoulder season Alder for next fall.
-
-
JKNW replied to the thread Let’s see some stumps.Little alder this morning. Been a while since I cut one that was still alive.
-
-
JKNW replied to the thread MS 660 aftermarket A/F.Max Flow are nice especially if you like the larger air cleaner cover. Egan Performance Saws makes a foam filter that fits under the...
-
