High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

Recent content by JIMG

  1. JIMG

    Dilemma

    Sometimes I will mill out just the best widest boards from a log and send the rest to the firewood pile. Up here we run through a LOT of firewood, the house, shop, in-laws are all 100% wood heat so it doesnt feel wasteful. You could also just cant it and seal the ends to slow drying but I...
  2. JIMG

    Not so pros 4 new and without politics

    My mom the nurse always told me regarding poor health statistics "Thank God for Mississippi. Otherwise Texas would be #1"
  3. JIMG

    SELLING 266se $350

    brmp.
  4. JIMG

    SOLD Stihl 051

    Sold.
  5. JIMG

    SOLD Stihl 051

    $300+ ship
  6. JIMG

    SELLING 266se $350

    $350+
  7. JIMG

    SELLING 266se $350

    $375 + shipping
  8. JIMG

    SOLD Stihl 051

    Bump I forgot to mention the muffler is opened up some, rebuilt fuel cap and it's got new starter components from sagenspezi.
  9. JIMG

    SELLING 266se $350

    This one is a solid runner with some upgrades. It has a new windowed meteor piston, base gasket delete, new filters, gaskets, nachi crank bearings, Duke's 272 carb., new clutch and drum, sprocket, shrink tube over the handle, muffler modded a bit, oem cylinder cleaned up, exhaust polished up...
  10. JIMG

    SOLD Stihl 051

    $350 plus shipping With the very good condition big bar and new chain. This one has been completely gone through. New av, lines, filters, gaskets, carb kit, oiler o rings, new aftermarket piston, cylinder cleaned up and exhaust polished. FW side bearing replaced, I have a new needle bearing...
  11. JIMG

    SOLD 181/288

    SPF
  12. JIMG

    SOLD 181/288

    No name on the piston or box it came in. I cleaned in the ultrasonic cleaner for a few minutes and installed it. It seemed ok on install and has run fine.
  13. JIMG

    SOLD 181/288

    Bump for the ol thumper
  14. JIMG

    SOLD 181/288

    I have a few things to fund and my 064 is on the way home so this one is up on the block. Husky 181se runner with an oem 288 cylinder and AM piston I got off a member here. No other upgrades. Muffler is stock, timing is stock. New lines, filters, Nachi crank bearings, seals, carb kit. spring...
  15. JIMG

    SOLD Jonsered 2165 with MMWS 2172 Cylinder. $450

    Revision...I did not replace the crank bearings on this saw. I have a pair of nachi bearings I had planned to use but never got around to it. I can include with sale if desired.
Top