jacktheripper's latest activity
-
Husqvarna 572XP -
-
If Meteor 242 piston is used it becomes a low compression turtle, with the same intake timing as the old 42 had. On Gilardoni 241 C or...
-
I replaced the throttle assembly with a nos after noticing the thing was not quite getting to full throttle. Got a few hundred more rpms...
-
jacktheripper reacted to JimG.'s post in the thread WANTED Jonsered 625/630/670 air filter cover with
Like.
Sounds good, let me know what you dig up. -
Steve has pointed out that his 242 has the same limitation. Cause: AM Meteor piston. The cyl is a new Gilardone but I haven't checked...
-
The BB's in the tank on a lathe is a slick trick.
-
You're supposed to be on top of these things before everyone else...
-
jacktheripper replied to the thread Not so pros 4 new and without politics or drama.Letting her roar this morning. Heading to Utah to pick up a snow machine carcass for the engine.
-
-
jacktheripper replied to the thread Fixing hole in tank.Redkote it is then!
-
$25 for 8 ounces of POR is not less expensive than $40 for a quart of Red Kote. I have used POR15 in the past and will say that in my...
-
In theory, you could make a base piece that had a cutter mounted. You can definitely modify the cutter for other chamber contours. If...
-
I did not make the squish cutter it is from dyno joe. The rings are interchangeable and can change what size cylinder you want to cut...
-
How do they compare to a 562? @huskihl
-
Main issue i get is these older saws need a muffler or something you might as well do all the gaskets around the cylinder. hard to not...
