jacktheripper's latest activity
-
Welcome Wahomey -
Same AM 372 muff...just drilled out the tiny pipe, made the hole bigger, welded on a deflector. Port-matched the inlet to the widened...
-
I would favor JB Weld, grind or sand (coarse grit) around the hole, JB all around, press in a piece of screen wire and finish with JB...
-
I would not worry about the tank sealer, generous amounts of JB weld on both sides around the bolt will work fine.
-
Some shelving like you would see in a parts room (Usually gray) used a 1/4"NC stove bolt with a flat screw driver slot and the head is...
-
That was my point
-
jacktheripper replied to the thread Fixing hole in tank.I’m leaning pretty heavily toward just putting a nut and bolt in with a grommet or rubber washers to seal it. I can access the hole...
-
jacktheripper replied to the thread Fixing hole in tank.I don’t think there’s enough meat in the thickness of the case to tap it and screw a plug in.
-
jacktheripper replied to the thread Fixing hole in tank.I Well the screw isn’t tight anymore after pulling it out haha.
-
My first thought was to put the screw back in. Lol
-
Thats great to hear- its not a common alloy at all to weld
-
jacktheripper replied to the thread SELLING McCulloch 10-10S, Stihl 056 Mag II & miscellaneous saw parts- A Royal Heef thread.PM inbound for 056 stuff
-
Stihl 040 / 041 and Stihl 050 / 051
-
All of them, I wouldn't have listed them otherwise. @srcarr52 welded countless chainsaws cases and cylinders both saving them from the...
-
My money's on @jacktheripper figuring out how to weld magnesium.
