jacktheripper's latest activity
-
Developing x-ray vision. That sounds dangerous. -
jacktheripper replied to the thread SOLD Husqvarna 346 oe 450.00.Not too high at all
-
With used junk, anything is possible. I just have never went into a new to me saw assuming something like that. If I got a saw under...
-
no worries
-
Id say crappy oil too, or running a very rich mix a few tanks and oil built up in the bottom of the CC. Then the saw was run near...
-
Naw - those look like pretty average wear marks to me. Most two-cycle pistons will pick up wear lines or marks. Apart from the burnt oil...
-
jacktheripper replied to the thread nm.That looks more like crappy oil. Carbon left from unburnt oil.
-
^
-
Be about $170 after shipping and fees. Still should easily be able to recoup that and keep a part or 3. @jacktheripper should buy this...
-
jacktheripper reacted to ManiacalMark's post in the thread SELLING Stihl MS650 Cylinder and Piston new with
Like.
Have to slot the mounting holes for an 064. Have my other 650 cylinder machined and ported ready for my 064. Thicker base is a plus for me. -
jacktheripper reacted to hacskaroly's post in the thread Preparing to port first saw - which one, and what method? with Like.
Since the K&N style filter worked so good on my 2100, I am probably going to do the same on my 272 and 372. It is a relatively simple...
-
My wife can take one look at a box and say, "Another cylinder, eh?"
-
Had to take advantage of the season. This is the one time of year when my wife doesn't question packages arriving at the door.
-
Yes, saved me, too!!
-
Hopefully one of those carbs will work :p