jacktheripper's latest activity
-
jacktheripper replied to the thread Preparing to port first saw - which one, and what method?.I went out today and dropped three trees in the mountains with the newly ported 272xp. One of them was a 24”+ standing dead rock solid... -
jacktheripper reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with
Like.
I wouldn't have ever thought a saw could run at all with that amount of blowdown. -
jacktheripper replied to the thread Preparing to port first saw - which one, and what method?.That makes sense. It sounds like I may benefit from a couple less degrees of blowdown (raise my uppers a couple degrees) to gain rpm in...
-
The only 660 stuff I have is the partial project saw I got from you :p
-
@Canadian farm boy has a nice write-up on the ms880. I followed his advice in that write up and my clone ms880 turned out very well...
-
jacktheripper replied to the thread SOLD Stihl 064 parts.@singinwoodwackr
-
-
-
A little grinding and some black paint and it will look pretty good
-
jacktheripper replied to the thread Preparing to port first saw - which one, and what method?.This seems contradictory to this: What do you mean @huskihl? Thanks for your replies!
-
jacktheripper reacted to huskihl's post in the thread Preparing to port first saw - which one, and what method? with Like.
A couple more degrees of blow down usually makes it a little bit more forgiving, but won’t hold RPMs as well in a simple down cut. You...
-
JacktheStitcher 😁
-
jackthepiper :D
-
jacktheripper replied to the thread What's on your bench?.I think it’s a bolt on. It’s a 2018 model.
-
Clip on or bolt on exhaust?