jacktheripper's latest activity
-
jacktheripper replied to the thread Firewood thread!!! Let's see what you got!!!!.I also brought a couple of buddies… both the 038 Mag and the 5105 are for sale 😉 -
-
jacktheripper replied to the thread Firewood thread!!! Let's see what you got!!!!.More work today with the 562xp. Not bad for two hours of sawing after work. I should add that this is going on two cords of wood now...
-
-
jacktheripper reacted to ammoaddict's post in the thread Not so pros 4 new and without politics with
Like.
Just had my 1st bladder scope since my cancer surgery. Looks good so far. Have another in 3 months. -
jacktheripper replied to the thread Show off your muffler mods.Got the baffle gone on my 038 Magnum II and enlarged the outlet hole
-
-
jacktheripper replied to the thread Firewood thread!!! Let's see what you got!!!!.I got 10 free cords of this stuff in piles from the city. Various elm, cottonwood, and other junk western “hardwood.” There aren’t a lot...
-
-
Very nice condition 372 oe, runs great. Low hour saw, got it in a trade a while back, just have too many saws at this point, so passing...
-
jacktheripper replied to the thread Whats on the Grill or Smoker?.This was last week. Pork shoulder and tri tip.
-
-
jacktheripper reacted to S&S_Work_Saws's post in the thread SOLD Stihl 440 w/ported 044 slant fin cylinder with Like.
I originally built this for a guy that never finished paying or picked up it up. It's a set of new aftermarket case, a new OEM gas tank...
-
jacktheripper replied to the thread Let's Build a 266.This is tiring. I’ll write more tomorrow. Lol
-
jacktheripper replied to the thread Let's Build a 266.Next, installed the crankcase onto the handle assembly. Line up the av mounts with their respective holes, and take care not to break...
-
-
jacktheripper replied to the thread Let's Build a 266.It looks like I skipped over installing the flywheel as well. I chose to do a timing advance on this saw when installing the flywheel...
-
-
jacktheripper replied to the thread Let's Build a 266.The next part is to check the squish. If you are using a factory cylinder and piston with a base gasket, you may decide to skip this...
-
jacktheripper replied to the thread Let's Build a 266.The next step is to install the piston. Before installing, I like to drip a few drops of oil on the bearings in the bottom end. Get both...
-
-
jacktheripper replied to the thread Let's Build a 266.The next step is to get the top end components ready for installation. I took my new caber rings and inserted one into the cylinder in...
-
-
jacktheripper replied to the thread Let's Build a 266.Well, it occurred to me that I never finished this thread, so here we go:
