It only takes a few minutes to touch a chain up and keep safe and productive. If you let it go to long it is much harder to put an edge back on and sometimes takes a couple sharpening s to get it back to where it should be. I sometimes cut in areas where there were old pastures and...
Thanks for the info Beaglebriar, I am on the other end of pa (west of 219) so not close to you. A year or so ago the 371 wanted to shut off when you went to idle but still ran fine other than that so I took it to someone (mistake) to go over it and check it out and it ended up with no...
Thanks for the quick reply but I lost you at MM Method. I am not a saw mechanic so be gentle. The saw has been sitting for over a year and since I have some time, I decided to tear into it and see if I could bring it back to life. So whats the MM method? Thanks!
I have a 371 that seems to have little compression and does not want to start. I am no mechanic but pulled the muffler and this is what the piston looks like. Your thoughts on what I should do next would be appreciated. Thanks!
I believe the saw used was a BeaverVarna with a white toothed chain with about a 4" Bar but not sure about the oil maybe a Musk(rat) oil. I would be very careful wondering around in that patch of woods with out a very good hard hat:yikes:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.