heimannm's latest activity
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.On some of the early attempts for the one man saw diaphragms I just used LocTite 380 to secure the plate to the diaphragm. In one case... -
heimannm replied to the thread MCCULLOCH The official McCulloch thread.Jeff (cini5) located this unusual piece of McCulloch for me. I cleaned it up a bit before putting it up in the display area...
-
-
heimannm replied to the thread Pro Mac 800 do's and don'ts.In reality the PM850 and/or SP80/81 mufflers will not actually just bolt up. The PM800 family use a strap on top of the muffler to...
-
heimannm replied to the thread JONSERED Jonsereds.Someone brought in a late model 70E for a good going over this week. I was reminded of the differences between the early and late...
-
-
heimannm replied to the thread So what did you buy today.jbl - I've hand both hands done and in both cases it completely resolved my issues. I did not heed the Doctor's advice on the first one...
-
heimannm replied to the thread Vintage Chainsaw Museum.Her large screen TV is up with a couple of additional base cabinets that I will be using for shipping supplies. We did have everyone...
-
-
heimannm replied to the thread Vintage Chainsaw Museum.Shelving brackets are up, standards for the other wall have arrived, and more brackets are on order. Kitchen cabinets are in place...
-
-
heimannm replied to the thread Mcculloch 797, Super 797 thread.I would start by pulling the flywheel, cleaning the points again, and rechecking the gap. The spec's call for .020" but I target 0.018...
-
heimannm replied to the thread Mcculloch 797, Super 797 thread.Your arrangement seems correct and does match what the IPL shows. Make sure the key is fully seated in the crankshaft and that any...
-
heimannm replied to the thread SELLING Ridiculousness.E) All of the above
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.String trimmer engine, great place to start a large scale RC model plane, boat, or car. Mark
-
heimannm replied to the thread Vintage Chainsaw Museum.I just got back from inspecting the shelving in process. 11 sheets of 4x8 plywood and 320 linear feet of 1x8 poplar so far. Mark
-
-
heimannm replied to the thread So what did you buy today.
-
-
heimannm replied to the thread Vintage Chainsaw Museum.Standards for the shelving are going in up front in the display area. A friend in town is busy putting the shelves together from 3/4"...
-
-
heimannm replied to the thread Walk over to your toolbox right now….Jim Rodgers (Mo Jim) had a friend that worked in the hospital and gave him a bunch of those surgical towels, I ended up with a few from...
-
