heimannm's latest activity
-
heimannm replied to the thread Vintage Chainsaw Museum.Interior door & trim are being installed this week. The alarm was tied in to the current building this week so I am now covered... -
-
heimannm replied to the thread What's on your bench?.
-
heimannm replied to the thread What's on your bench?.While I'm waiting for the video, here is another unusual one we cleaned up for the display this week. Fairly late model "Redzaw" ICS...
-
-
heimannm replied to the thread What's on your bench?.I will post the video if it ever gets up on YouTube... short answer, yes. oils too. Mark
-
heimannm replied to the thread What's on your bench?.All done and in the display now complete with the original A-8 Auto Mac self sharpening chain. Mark
-
-
heimannm replied to the thread Old Homelite project 🤔.I have used some similar heat shrink tubing for handle bars, you have to work it pretty carefully to avoid wrinkles in the inside...
-
-
heimannm replied to the thread Old Homelite project 🤔.I don't know those two in particular, but in general all that I have tested were around 0.2 - 0.25 µF. Mark
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.I think we have a solution for the missing 55063 "capillary seal" in the fuel cap for the older and large frame saws. McCulloch tried...
-
-
heimannm replied to the thread HOMELITE Homelite Thread.Thanks Tim - Chris Bean has given me the same information. I have some ordered from LRB, I will report back once they arrive. Mark
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.Too tired to repost it all, but we worked through a primer on the BP-1 today. Details may be found on AS...
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.Those covers will be interchangeable. Some of the older saws had a different arrangement for the stop button, but even those will...
-
heimannm replied to the thread What's on your bench?.BP-1 is (was) a unique "balanced piston" design with one piston firing, and the other acting as a counter balance and sliding intake...
-
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.The starter assembly from almost any left hand start saw will work other than the SP125 and 1-40/1-50 saws. The SP125 starter will work...
-
heimannm replied to the thread So what did you buy today.https://www.google.com/search?q=5752557-03&sca_esv=4ba3af865432350d&sxsrf=ANbL-n4T_J_VuS7e8Xg9mBakF8iJLAAsBA%3A1768617032810&source=hp&ei...
-
heimannm replied to the thread What's on your bench?.The BP-1 is getting a good clean up, I will do my best to make it operational, then fit it with an Automac bar and chain and put it in...
-
