heimannm's latest activity
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.Is this the green solenoid you are referring to? Thanks, Mark -
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.Large 3 shoe clutches yesterday...I came up with 6 different part numbers, 3 for the SP80 and 3 for the SP125. The differences include...
-
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.I did put the 1140 007 1802 solenoid and fuel filter in the MS362C and the saw did exactly what it is supposed to do. In the end that...
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.The recoil starter spring is the same on all of the large frame saw whether right or left hand start. The 1-61 and 1-71 use the same...
-
-
heimannm replied to the thread Mcculloch 797, Super 797 thread.I have 69241 (+0.010") and 69242 (+0.020") piston assemblies that are used with the 69408 (1/2") wrist pin. That's my only...
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.This one came in in February, customer said entirely his fault. He did not read the instructions correctly and left it on high idle...
-
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.Thanks all, I will try the solenoid and filter and report back on Monday. Mark
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.I have an MS362C in the shop, customer says it falls on its face under load. The label on the handle says it is version 3.0. I when...
-
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.Rather than tear the engine completely down again, I swapped the flywheel and starter shaft from an 850 that allowed the cover to fit...
-
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.I put a note in the small parts bin with the dowel pins so hopefully I remember to check these in the future. I also noticed there are...
-
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.I was putting a PM800 together and learned a valuable lesson about the dowel pin (110851) used to locate the bearing insert on the PTO...
-
-
heimannm replied to the thread SELLING Throw away chainsaws.Shane - I sent a message. Mark
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.I just make some blanked off "gaskets" from Buna N material and use the carburetor and muffler for my block off plates. Mark
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.You might as well make those parts Chris, you will be needing them again for additional projects...
