heimannm's latest activity
-
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.Chris - do you know what the cylinder and piston measurements should be? I don't mind putting a piston in it, but I'd like to know the...
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.The crankshaft is on its way here now. I tried contacting the seller to see if they would make a package deal but no reply, hopefully...
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.I went ahead and tore the 170 apart, piston and cylinder look fine but compression is only 105 PSI. Mark
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.Fellow brought in a really whupped MS170, basically no compression. He really wants it going again (sentimental reasons...) and I'm...
-
heimannm replied to the thread HUSQVARNA HUSQVARNA THREAD.Customer brought in a 66 (not a 266) with no spark. I checked the coil and I believe it tests good, any ideas on where to find the...
-
heimannm replied to the thread The unpopular opinion thread.
-
-
heimannm replied to the thread Vintage Chainsaw Museum.The city of Dike has their "Watermelon Days" this weekend, I am planning on getting a few saws ready for Baraboo and putting them on my...
-
-
heimannm replied to the thread POULAN The Official Poulan Thread.The CV models were very fine saws. I have a 5400 that I still use from time to time, and another in the display in my small chainsaw...
-
-
heimannm replied to the thread Vintage Chainsaw Museum.Today they poured the slab at the back end of the new building, later this week they are supposed to get the roof trusses up and the...
-
-
heimannm replied to the thread What's on your bench?.The P50 sounds like it is ready...for almost anything. Mark
-
heimannm replied to the thread Vintage Chainsaw Museum.Philbert - A little bit of both, but mostly for more room in the attic of the new building. Our plan is to move all the parts inventory...
-
heimannm replied to the thread Vintage Chainsaw Museum.With the (Decra) steel shingles, you have to remove quite a few to create an opening. The floor in the existing attic is about 3'...
-
-
heimannm replied to the thread So what did you buy today.I felt like the vitrified wheels loaded up or glazed over very easily leading to overheating of the chains. Grinding seems to be pretty...
-
-
heimannm replied to the thread HUSQVARNA HUSQVARNA THREAD.I replaced the fuel line last year with the good stuff from Echo. Fuel filter is clean, it behaves more like it it too rich after a...
