heimannm's latest activity
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.Many of those saw did not use a gasket, the or steel aluminum body of the "muffler" just clamped directly to the cylinder. That said... -
heimannm replied to the thread So what did you do today?.@EFSM - thank you so much for that lead, it is indeed the governed carburetor. I had not encountered that before on an HL model and...
-
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.Thanks Ray - the Clymer manual shows the governed carburetor and @EFSM pointed out in another thread that some had that limiter rather...
-
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.Thanks JJ, I just needed a little push in the right direction... The text gives a value of 0.17-0.19 µf, I will have to pull the...
-
-
heimannm replied to the thread STIHL The Official Stihl Chainsaws Thread.TS 350 that I just went through. It is hard to tell from these photos but the transformation was pretty dramatic. It is back...
-
-
heimannm replied to the thread So what did you do today?.It is back together and runs, but has an unusual miss at higher speeds. Sounds to me like an ignition issue but I've been over the...
-
-
heimannm replied to the thread So what did you do today?.This is a TS350 if I can read it correctly, points ignition. Cleaning the old concrete off these is a chore. It will look much better...
-
heimannm replied to the thread So what did you do today?.I did notice while taking this one apart that the air vane mechanism is all missing, or did they not equip the cut off saw with the air...
-
heimannm replied to the thread So what did you do today?.He wanted me to go through it, clean it up and make it run again. I'm working on it... Mark
-
-
heimannm replied to the thread So what did you do today?.
-
-
heimannm replied to the thread McCulloch Chainsaw ID?.Super 44, AF cover is on backwards 1-4X, possibly a 200 I will defer to Bill PM610 Nothing significant there, the Super 44 @ 80cc and...
-
heimannm replied to the thread What's on your bench?.3 phase motor on my lathe failed me...stuff on several benches. I was in the process of tumbling the fuel tank for my buddies 200 amp...
-
-
heimannm replied to the thread MCCULLOCH The official McCulloch thread.Many use Rustoleum Sunburst Yellow but that is a bit more orange than the original, very close to to the later Pro Mac saws like the...
-
-
heimannm replied to the thread Vintage Chainsaw Museum.I guess it was finally cold enough and there was enough snow on the ground that the gas company decided it was a good time to run the...
-
-
heimannm replied to the thread What's on your bench?.The 33 LeSabre and Thrifty Mac were apparently put together hurriedly to provide a direct drive saw for the pulp wood cutters in Quebec...
-
