hacskaroly's latest activity
-
hacskaroly reacted to Bill G's post in the thread SELLING Husqvarna / Husky 298xp PARTS ONLY!!!!!! Runs perfect!!! with
Haha.
The 298 is a bitcch to start..... -
hacskaroly reacted to aarongd's post in the thread SELLING Husqvarna / Husky 298xp PARTS ONLY!!!!!! Runs perfect!!! with
Like.
it starts easy but hard to crank. ALOT!!!! of compression -
Im still running Dolmar oil in my stuff but I run this in a TS800 I keep on my truck. Too many of these boneheads will fill a gallon gas...
-
hacskaroly replied to the thread HELP! Ms441c Reset Trouble.Glad to hear is seems to for the most part be running good!!
-
Ran it yesterday it ran pretty good, idle acted up a couple times within 5 straight hours of cutting, so I won’t throw it in the river yet.
-
I continued on the unidentified Disston today, interesting fuel and pulse set up. The fuel valve and fuel pump are located on the...
-
hacskaroly reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
I have a few 51483, 51561, but no new 51809 (reed valve). My understanding is these were Jenn Feng era saws but according to Mike Acres...
-
hacskaroly replied to the thread John Deere 410 back hoe.I say that about chainsaws...and then I say...this is the last one...I swear!! And then another one shows up at the house....
-
I didn't know where to put this so I landed it here .Much of my life I've just been at the right place at the right time and when I...
-
hacskaroly replied to the thread MCCULLOCH The official McCulloch thread.I have those on my D44 and they were quite stiff, I was worried I was going to crack or break them when I took the saw apart, luckily I...
-
hacskaroly reacted to Sleeper's post in the thread MCCULLOCH The official McCulloch thread with Like.
Hello. Finally got around to working on the S44A again. (Yeah, the one I started about 5 years ago) Looking for two parts, and they...
-
ebay-see saw run 036 filler cap I have bought a couple thing from these guys for an 026 and 036. All have been correct
-
Looking for an oil cap for Stihl 036 NOS.
-
hacskaroly reacted to jacob j.'s post in the thread WANTED HDA-87 for 262 build (member: 7-pin) with Like.
This is a want ad for member @7-pin : "I have a 262xp with a Walbro HDA 120 out for port work. I've been searching for weeks on...
-
hacskaroly reacted to brushwacker's post in the thread SELLING Husqvarna 55 Rancher parts or project with Like.
I can sometime after APRIL 15 should be easy enough maybe sooner but it likely be short notice if prior. Have some pressing tax work...