hacskaroly's latest activity
-
Not his first rodeo. -
hacskaroly replied to the thread Old Homelite project 🤔.Dang, now you have me looking at parts on that site. I did get my Super XL out over the weekend and fired it up. I have not done much to...
-
hacskaroly replied to the thread Old Homelite project 🤔.I hope it works out too, if so I may have to get one for my Super XL. I have not looked at the spur sprocket recently, but I am sure it...
-
Is it possible to make 28" chains work on both husky & stihl mount bars. I would like all my 28" chains to be interchangeable between...
-
hacskaroly replied to the thread HELP! 28" Chain Dilemma.I would imagine a 92DL would be quite tight on the Husky, but work out as it stretches, unfortunately it may stretch past what the Stihl...
-
hacskaroly replied to the thread Grease Monkey Garage.Yes I did. I had wondered about that, kind of hoping it was a bad sensor and not an air leak. That make a lot of sense with the...
-
Didn't you mention a head gasket issue in an earlier post? If any air got into the cooling system, it will have exactly the issues...
-
Got a John Deere 1025 today with loader, third function and a rear blade like this one.
-
Sounds like you're temp sensor is working ok, it's your thermostat that is stuck open not allowing the coolant temp to rise. That would...
-
hacskaroly replied to the thread Grease Monkey Garage.I guess that is a possibility, I replaced it less than a 1,000 miles ago, but I may have to revisit possibly replacing that again...
-
Nope
-
I would think the replacement sensor should be at least close to the factory Ohm spec, otherwise the ECM couldn't work with it.
-
hacskaroly replied to the thread Grease Monkey Garage.That is what I thought too, but perplexing that the OEM is 80% working (it seemed to quit as I was driving home, needle settled to the...
-
Hater…
-
hacskaroly reacted to Hinerman's post in the thread New Release: MaxFlow under lid "MINI" Filter Kit for Stihl 500i & 661 with
Haha.
They have so much power they will suck in everything within a 15 foot radius ;)
