hacskaroly's latest activity
-
Yep, that’s the check valve -
On the carb I'm having issue with, there was a round piece of thin transparent film floating around on that side.
-
I think that the issue is with the check valve material inside of the nozzle. It must seal tightly at idle, and allow fuel to flow...
-
The OEM carburetor has the tan Mylar and the aftermarket carburetor has a black plastic pump diaphragm. I wouldn’t worry about it but it...
-
,
-
I've never replaced a nozzle. Just punch the old one out and tap a new one in?
-
hacskaroly replied to the thread Carburetor talk - fuel puddling.I messed with one on one of my Husky saws, can't remember which brand, but yeah, use a punch the same size (or close) as the nozzle and...
-
hacskaroly replied to the thread Stihl 361 Leaky Carb.This is more of a general question for everyone, but shouldn't it be an issue for fuel to be coming out of the impulse hole - shouldn't...
-
It held at .5 for about 10 minutes. It’s holding pressure but pushing fuel out of the impulse hole.
-
hacskaroly replied to the thread Carburetor talk - fuel puddling.Very cool, I wonder what the nozzle issue was, something clogging/partially clogging or maybe erosion creating a larger opening? I...
-
I have an update on all of this. I ordered two new nozzle/check valve assemblies for my saws and installed them on my HD-14 and HD-16...
-
hacskaroly replied to the thread First time modifying a cylinder.I would think if you are using a flat top piston, then probably not, if it is a pop-up then it might hit the booger.
-
-
-
10-4, I won't be pulling the engine apart but I can soak it. I've use Quicksilver Power Tune which is of a similar nature, and it...
