hacskaroly's latest activity
-
I just ordered 503627201 for a 365 special I am planning on shipping out to get rebuilt/ported, I hope it is the right one. -
All the same
-
I'm pretty happy with the results . Adjuster block slides smoothly throughout its travel fore & aft . Epoxy seems very strong 👍.
-
Kev thanks for sharing. We have a confirmed 2511 brake job gone bad, had to be fixed by a former admin. Two out of Two stepped outside...
-
No tips other than practice. I have old used scored pistons in every size that I slide up into the bore repeatedly and look for...
-
hacskaroly replied to the thread Old Homelite project 🤔.Very nice, glad to hear it is holding! It's a pain to clean up because it is hard, but does a good job. I was using some JB Weld on a...
-
JB weld for the win ! (So far) This part of the case cover was cracked along where the tension adjustment screw is . To the point where...
-
As someone with no CNC experience, I would not feel satisfied with that. However, centering the exhaust roof is something I struggle...
-
hacskaroly reacted to EFSM's post in the thread STIHL trimmer dies when letting go of the trigger with
Like.
Thanks for being thankful. That is a dying character trait. -
hacskaroly replied to the thread STIHL trimmer dies when letting go of the trigger.That is great to hear, I wonder what was up with the old carb, I guess partially clogged somewhere? Did you go OEM or AM on the carb?
-
hacskaroly reacted to Merkava_4's post in the thread STIHL trimmer dies when letting go of the trigger with Like.
- EFSM - hacskaroly - Coupe - lehman live edge slab ThankYou all for replying to this thread. Very much appreciated. :beer-toast1:
-
hacskaroly reacted to roloc1's post in the thread ECHO 90014 3mm X 5mm) and 90015 (3mm X 6mm) Fuel Line and Ethanol with Like.
Thank You Much. I really appreciate the information. Like our gas cans, 55 MPH speed limit, Unleaded Gas, Ethanol, DEF, Particulate...
-
hacskaroly reacted to roloc1's post in the thread ECHO 90014 3mm X 5mm) and 90015 (3mm X 6mm) Fuel Line and Ethanol with Like.
Thanks for the tip Jacob J. I will have to give Duke a try. Take care and stay blessed.
-
Ripsaw ports the 2511 cylinders on a CNC. Customer sent me one to compare to one of mine and improve upon it if I could. The exhaust was...
-
Too many people fall for the supposed “perfection and repeatability” with cnc. It’s a great idea if they actually found a good solid...