hacskaroly's latest activity
-
hacskaroly replied to the thread Old Homelite project 🤔.Doesn't look that bad at all, some scratched paint and a little bit of dirt, but otherwise it looks to be in good shape! -
No scoring on the slug viewed through the exhaust port , just carbon . I would replace e all the fuel lines and rebuild the carb . I...
-
I use a steering wheel puller from any auto parts store, and long screws.
-
hacskaroly replied to the thread HELP! Ms362 service manual and IPL?.@ray benson Ray may have access to those.
-
I met a guy that got himself wrapped up and yanked on so hard by a large angle grinder that it jacked his back up, put him on permanent...
-
Angle grinder,,, you smell the damage before you feel it,,,,trust me,,
-
Lathe accidents? Been thirty odd years. A guy had a conveyor roller shaft set up in a lathe. The shaft was too big to fit inside the...
-
I was getting it closer and closer trying to get it out of a shadow. Completely focused on not buggering the inside of the carburetor...
-
You have to watch a few videos on YT "Idiots in work" 😉 👍 you can avoid a few mistakes this way 😎 I watch it myself 🤠
-
The ones starring @hacskaroly?
-
hacskaroly replied to the thread Old Homelite project 🤔.I guess the things to check first, are the piston/cylinder scorred? Fuel lines rotted? Need a new carb kit diaghprams? Fuel and air...
-
@heimannm I know it’s not a McCullough…
-
I had to get the only one I’ve seen with a full wrap handle.
-
I just finished restoring a XL-1 and a super mini. They are fun saws
-
I have a nice one here, everything seems to work as it should...
