hacskaroly's latest activity
-
If this clutters up Greg's build thread too much hopefully a mod can delete my post. But all of these builds are kinda his fault after I... -
I would like this thread to be useful to folks down the road. That being said, I think this is a great addition. I'm sure other folks...
-
How about tank vents falling off? I worked on several earlier this year where the white vent fitting wouldn’t stay in the tank and I...
-
You can post up what you found. I do need to touch on tank vent modifications at some point in this thread for saws with the EPA vent...
-
This is what it looks like when the vent is missing. This is on a saw with a primer (I can’t remember if all the 350’s have primers)...
-
hacskaroly replied to the thread Husqvarna 350 build thread.Sorry, I am not sure if I am picking up what you are putting down...did you make a spacer from an old oil seal to take up the slack...
-
Thanks for the bump. Erie, Cool old saw! Good luck.
-
Have you altered the intake duration? Do you get spitback out the carb?
-
No spitback, two of the saws were very much altered, but professionally by @drf256 and @Mastermind and the issues go away with different...
-
It is winter time and im surprised nobody hasn't mentioned the issues that come from cold weather ops. All Carburetors like warm air...
-
Checked with a couple dealers and found one that had a WT-426B carburetor for $80 It doesn’t have the limiter tab on the high jet. But...
-
Oh, I have a small pile of those, I think only one left with the stock dished piston. A couple of them are now 346s. Some of these are...
-
There is definitely value in taking some time to modify the stock 350 for a low-buck rig. If you have run a good ported 346xp, you can...
-
Problem with the one I have that does this is that the tune that holds idle when you pick it up doesn't accelerate well and the tune...
-
That is actually what I have been doing on a couple of saws in order to pick them up. The blips do work, and you can tell that it’s...
