hacskaroly's latest activity
-
Buckle your seat belt, because here comes the learning! -
Finally got the saw. Didn't get the muffler off for piston pics yet but she fired up decent after replacing the fuel. Smoked on startup...
-
hacskaroly reacted to Khntr85's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with
Like.
Ya ya a pass for me once looked into it more and the reply’s here, to much for what it is!!!! -
hacskaroly reacted to singinwoodwackr's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with Like.
Looks like a typical used tree service 201 :p The muffler bolts can loosen up and the muffler burns the floor of the tank. Depends on...
-
hacskaroly reacted to Khntr85's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with Like.
Ok boys sounds like a hard pass just seen it on the book face..
-
hacskaroly reacted to Ketchup's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with Like.
Yeah, something is up with the muffler. Could just be running it with only one muffler bolt but it looks like there’s some sort of...
-
hacskaroly reacted to jmester's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with Like.
If it runs good, I would stick to your 200 offer. To fix the hole it would need a tank. And based on the pictures it will probably need...
-
Looking for repair manual for ms 261 c-m. Thanks in advance.
-
hacskaroly reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with Like.
https://www.oldsawshop.com/Walbro-K-10-SDC-Carburetor-Kit-p612067466
-
hacskaroly reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with Like.
-
hacskaroly reacted to Khntr85's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with Like.
From what I looked up the muffler can come loose and cause this….guy wants 250 for it says runs but haven’t went and looked yet….i...
-
hacskaroly replied to the thread HELP! 201c what causes melted bottom plastic pics included!!!.I would say that loose muffler or hole in muffler is a possibility. Might be running it leaner than 50:1 (eyeballing pouring in the mix...
-
hacskaroly reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
I also have some specific questions about expansion chamber pipes: How many degrees of rotation can the pressure wave force charge back...
-
hacskaroly reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
Sure, I’ll bite. So you seem convinced that a dual outlet crack-pipe (sorry, I’ve always called it that because the single outlet ones...
-
Pam
