hacskaroly's latest activity
-
hacskaroly reacted to jmester's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with
Like.
If it runs good, I would stick to your 200 offer. To fix the hole it would need a tank. And based on the pictures it will probably need... -
Looking for repair manual for ms 261 c-m. Thanks in advance.
-
hacskaroly reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with Like.
https://www.oldsawshop.com/Walbro-K-10-SDC-Carburetor-Kit-p612067466
-
hacskaroly reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with Like.
-
hacskaroly reacted to Khntr85's post in the thread HELP! 201c what causes melted bottom plastic pics included!!! with Like.
From what I looked up the muffler can come loose and cause this….guy wants 250 for it says runs but haven’t went and looked yet….i...
-
hacskaroly replied to the thread HELP! 201c what causes melted bottom plastic pics included!!!.I would say that loose muffler or hole in muffler is a possibility. Might be running it leaner than 50:1 (eyeballing pouring in the mix...
-
hacskaroly reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
I also have some specific questions about expansion chamber pipes: How many degrees of rotation can the pressure wave force charge back...
-
hacskaroly reacted to Ketchup's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
Sure, I’ll bite. So you seem convinced that a dual outlet crack-pipe (sorry, I’ve always called it that because the single outlet ones...
-
Pam
-
+1
-
-
Thanks Mark . The best description I can give is its a mid 90s Craftsman 42cc model . It doesn't make sense to me to have the return...
-
hacskaroly reacted to SawAddictedFarmer's post in the thread Ms362 base gasket delete and timing advance? with Like.
It sounds nasty!
-
Saw has been shipped. Sending buyer tracking info.
-
hacskaroly replied to the thread Husqvarna 525ecs Edger conversion.Looking at the specs for the two (525L vs 525ecs), they look like they might be the same, the only difference I see is the maximum RPM...
