hacskaroly's latest activity
-
I have always just tightened them as much as I could with the various clutch tools I have which are not great. Have not had one come off... -
Nothing like a clutch burnout on the shop floor
-
I honestly never do more than spin it on by hand but all mine are inboard clutches.
-
I have done this (torquing using piston stop) and had them come loose. But each person needs to figure out what works for them. And yes...
-
Exploding a clutch in the shop is a rite of passage. That moment when you realize you still have both eye's is priceless. Also you...
-
5-series are evil…
-
I have around 2 doz project saws, most are complete and cleaned, just need assembly. More, if I add up the 200ts.
-
hacskaroly replied to the thread So what did you do today?.I just picked up a 545 and 365 project saws...need to dig into what they need.
-
Well…they are still in boxes 🤣 You wanna build one for me?
-
Didn’t know if this was posted already…annoyingly watermarked
-
hacskaroly replied to the thread So what did you do today?.I'm looking hard, but don't see a 2100 at work there ...sigh....
-
Almost done cutting the giant rounds into movable chunks. Stihl have the stump to cut down but will wait till there is more room around it.
-
I hand tighten There are a few ways to get things tight, but the saw, in theory will tighten the clutch down as it’s turning in the...
-
Some people have no sense of adventure!
-
Well, you're no fun...
