hacskaroly's latest activity
-
Didn’t know if this was posted already…annoyingly watermarked -
hacskaroly replied to the thread So what did you do today?.I'm looking hard, but don't see a 2100 at work there ...sigh....
-
Almost done cutting the giant rounds into movable chunks. Stihl have the stump to cut down but will wait till there is more room around it.
-
I hand tighten There are a few ways to get things tight, but the saw, in theory will tighten the clutch down as it’s turning in the...
-
Some people have no sense of adventure!
-
Well, you're no fun...
-
Very thorough and honest review Tim - looking on the website, it appears they've put a lot of engineering into this grinder. A lot of...
-
It was pretty hard to find any info on the relatively new CZ223 square grinder, so when there was some money in the work budget for a...
-
Thank you , I watched her video . I don't think this uses the different sizes of fuel line as the nipples are all the same OD.
-
hacskaroly replied to the thread Need a little guidance.I have a Poulan Woodshark that is about the same size as this one. I know it uses two different sizes of fuel line, not sure if that can...
-
-
Hello all used a inpact to remove the clutch from my saw and now im ready to reinstall it. Do I burb it back on with the impact or go...
-
Hand tight works just put it in a log for a second right after starting. Or do it with the impact. Either way works.
-
I use an impact to reinstall them. I used to use a piston lock and ratchet but I found the impact to be more reliable. Just make sure...
-
Torque to spec if possible. Have had a few things come loose ‘impact tight’. Don’t reinstall with starter recoil installed
-
hacskaroly replied to the thread Reinstalling clutch.Don't forget to put the clutch cover back on when testing the saw, don't want a clutch to come loose and spin off of the saw at great...
