hacskaroly's latest activity
-
Many folks have already done a good job of addressing your question but I will give you a real life example of a situation here that... -
hacskaroly reacted to Mad Professor's post in the thread HELP! Understanding piston design with
Like.
Cutouts change port timing of transfers and direct flow -
Can someone explain the piston design of my cs-400 ? I understand the concept of the pop up piston taking up space in the Squish band...
-
After looking at some 2011 conversation on AS with Mark, Chris and Aaron, it appears the 361 never had an auto oiler and were 59cc. The...
-
I'm not sure exactly which model Poulan this comes from, may be the 361 but the tag on the saw says 4.0 In3. Mark
-
The early growth rings are something else! I envy the OP's patience...
-
Thanks for the extra encouragement. I had been considering a few other builders when I stumbled across his name on the forum when...
-
The Dayton is ready for the display. Mark
-
Someone put in a Chinese ignition coil / I put in Walbro Japan and it works fine 👍🤠 although the coil is from a smaller and newer...
-
If you get an 036/360 cylinder you have to trim the air dam under the front of the top cover. Just a reminder before you go nuts trying...
-
I know it's a longshot but here goes...someone came in looking for the AF cover for a 285CD. This one is broken out in the back...
-
I finally found an IPL for that saw .Much to my surprise the list not only had a parts number but also a discription of the part .I was...
-
Well everything is back together and other than a leaky tank vent it's running fine. Thanks all for the help!
-
hacskaroly reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
25/250 left side ms 180 right. Think you need to slit gasket a little to make it pull vacuum correctly
-
Ha, ha No expert status my friend. But thx for the compliment.