hacskaroly's latest activity
-
Hello. Need husqy 3120 carb with h-jet (maybe 2 carbs). Can anyone sell this for me? -
hacskaroly reacted to qurotro's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
loosen all the case screws and heat the bearing pockets around 300'F it will let go with minimum efforts. -
Honda Bond HT. I use it sparingly but everywhere. From the filter base to the cylinder base, not on the exhaust side. I don’t like...
-
News to me. I use a little white Dirko on Stihl case gaskets because it’s cheap insurance and it’s white, so it doesn’t look...
-
Got the saw. “Deep” clean with some compressed air, and Dawn power wash. Fresh mix, and a lot of pulls. Presto, she runs. Chain is...
-
hacskaroly reacted to Al Smith's post in the thread MCCULLOCH The official McCulloch thread with Like.
"Vintage Vixen was selling the "L" wrenches again recently under a new eBay name".( Mark )-----and she's selling them for around 50...
-
hacskaroly reacted to Woodslasher's post in the thread MCCULLOCH The official McCulloch thread with
Haha.
True, but in the other shop bay there are a few nut and bolt bins I could check first: -
I guess I haven’t heard that 026 base gaskets leak. But when I do use a base gasket, it always gets a thin layer of motoseal on both...
-
hacskaroly reacted to Sloughfoot's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
That makes sense. I've got regular length short nose vise grips and some really long ones that flex and don't hold that great. I think...
-
hacskaroly reacted to heimannm's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Mike (Glock57) convinced me the stud removal tools were an essential item, I've used them several times and they are great no doubt...
-
hacskaroly reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Dan - the clutch nut is 3/8-24 just like the bar nuts. You can probably find them at your local hardware store or the next time you...
-
hacskaroly reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
The spline socket is 85584, there is also a "L" shaped wrench PN 85583. Vintage Vixen was selling the "L" wrenches again recently...
-
hacskaroly replied to the thread Sealant or not?.Yes it is!
-
This it...
-
That settles that. I've heard base gaskets tend to leak on 026s. Will sealant + gasket prevent that?