hacskaroly's latest activity
-
Thank you for sharing sir! -
He said the whole saw was gone through so bearings and all. I feel like everything is getting more expensive these days.Thanks, gents!
-
hacskaroly replied to the thread HUSQVARNA HUSQVARNA THREAD.I am not a good judge of price, but I found a 272xp at the dump that ended up taking about $200 in parts for bearings, gaskets, piston...
-
Let's keep the child side of things better off un said. Dan is not an idiot. Unfortunately the head moderator has done some out of...
-
hacskaroly reacted to Loony661's post in the thread HELP! So where do we go from here folks? with
Like.
I understand what you’re getting at. However, being able to speak lewdly and constantly reading that nonsense isn’t a requirement to be... -
hacskaroly reacted to ammoaddict's post in the thread HELP! So where do we go from here folks? with Like.
Thanks for that explanation and also thank you for taking on this responsibility. Make OPE Great Again.
-
hacskaroly reacted to 59billy's post in the thread HELP! So where do we go from here folks? with Like.
We're all confused. What follows is my understanding, and I'm willing to be corrected. Current moderators are @SOS Ridgerider , @jacob...
-
hacskaroly reacted to lehman live edge slab's post in the thread HUSQVARNA HUSQVARNA THREAD with Like.
I actually despise the stupid plastic carb block of the 55 and alike rancher series saws. Ham fisted people always seem to have them...
-
hacskaroly replied to the thread HUSQVARNA HUSQVARNA THREAD.I can agree with that, with my 55, 272 and 2100, they are basically just bigger versions of each other and I find the 2 series some of...
-
Everything on that saw is simple… I don’t know why you had such a hard time. Probably one of the most straightforward saws you could...
-
hacskaroly reacted to huskihl's post in the thread HELP! So where do we go from here folks? with
Haha.
Butthole works great. Thanks Dewey😂 -
under two weeks to go comrades. sounds like theguy i work with will be free and he seemed into bringing some gear over, i imagine people...
-
hacskaroly reacted to huskihl's post in the thread HELP! So where do we go from here folks? with Like.
Thanks. I can be an *a-hole now and then when it’s needed but I always try and do good work. Backed up quite a ways
-
hacskaroly reacted to Shane¹'s post in the thread Question about crank case seals during reassembly after splitting a case - Dolmar 6421 with Like.
There is a good taper on the flywheel side I am sure it will slide together fine and you won't even need a new seal
-
I bought a 661 from him and sold him a 2095. Never a problem.