hacskaroly's latest activity
-
hacskaroly replied to the thread Rich coming off of WOT.Looking forward to hearing how it goes!! -
I took a punch and folded the idle hole half shut and the same with the first transition hole. Beat a new plug in there and set the...
-
The needle should be before the plug. And, of course, the entire volume of fuel remaining after WOT behind the L needle will count if it...
-
Im liking this discussion. My biggest problem in life is i always need to know why. Another carb might solve the issue, but why? What is...
-
I don't think that is the result of the rail closer, the bar just wears out, cheap bars wear out faster, the rail closer just buys you...
-
People say that they can help a bar with a sloppy groove get a little more life, but that they don’t work magic. Some bar rails...
-
hacskaroly reacted to Sloughfoot's post in the thread Raising The Uppers With The CC Speciality 182 AMC with
Like.
That helps a lot. Do you remove the nikasil/chrome beforehand with a diamond or ferrous bit or take it off too with the nonferrous bit... -
hacskaroly reacted to Mastermind's post in the thread Raising The Uppers With The CC Speciality 182 AMC with Like.
I talk to a lot of guys that tell me how they have trouble with the right angle handpiece jumping and chattering in the corner when they...
-
Well, maybe its a good thing I got 1/8" filler rod, 🤣 . That would be exciting to have a magnesium rod burning out of control.
-
If you do catch it on fire snuff it out with the argon from your torch... don't try to blow it out like I usually try first!
-
hacskaroly reacted to FergusonTO35's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Not yet, planning to.
-
hacskaroly reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
You advance the timing and open the muffler up yet? After doing that it will be close to a stock 201.
-
When I have encountered this very problem, a little more rich on the low side and a little more RPM on the idle screw fixes it 95% of...
-
Then check and tune the relationship between the Lo and idle speed settings. If they are off and one is compensating for the other in...
-
