Gavinmalloy18's latest activity
-
GAs the title states nib with tools and manual Bigger clutch cover 1450 shipped to the lower 48.
-
GOh, I put a new elastostart on it too.
-
GI've probably ran it on 7-8 jobs since Kev did his thing and all is well, it rips with bars 28" and under.
-
GLong story short, this was my first 462 Kev ported and it cracked the intake side of the piston. I sent it to him to look over/fix and...
-
GGavinmalloy18 replied to the thread SELLING MS461.Nice saw!
-
GFor sale is a stock good running ms462c, starts and runs as it should. Also included Is a modded muffler cover not installed, asking...
-
-
GGavinmalloy18 replied to the thread FOUND IT 661c.Sorry, I just seen where you sent the link and it’s a non arctic. My bad🤣🤣
-
GGavinmalloy18 replied to the thread FOUND IT 661c.So it’s the 1/2 wrap arctic 661c correct?
-
GGavinmalloy18 replied to the thread FOUND IT 661c.Ok, wasn’t sure if you decided to keep or sell that one since it was the last one you had.
-
GWould like a nice preferably stock but may consider ported 661c. Prefer all oem and mtronic, nicer the better.
-
G2021 MS 400c with full wrap handle Red beard intake and filter WCS bark box WCS felling spikes Oversized clutch cover 800.00. PayPal...
-
GGavinmalloy18 reacted to ELECT6845's post in the thread SELLING Jonsered 2171 cutters edge with
Like.
Saw is in good shape with only a few scratches and scrapes. OEM cylinder with good compression. 16” bar with carbide chain .404... -
GLooking for a nice stock ms460 or 046 all oem
-
GUgh. So nice. GLWS
