Gary Courtney's latest activity
-
I'd replace them ALL with steel cap screws. Any good hardware store...... -
I think as far as your saw is concerned, if it runs good you are done. It will still work as it should I think. I’d seek out help if it...
-
I’ve owned one since 2018 and lately had to fight them for a software update. I think I was just lucky in that I purchased it from a...
-
Gary Courtney replied to the thread MDG1 To Be or Not to Be !.Also after I rebuilt and before I was told it had to be re-calibrated I cut up a large pin oak and it ran perfect,idled perfect so I...
-
Gary Courtney replied to the thread MDG1 To Be or Not to Be !.I just rebuilt a 500i and some members say I must do a recalibration? Manual says 5 bucking cuts and it will reset. Members say negative!
-
Forget it. It is dealers only and it is good that not everyone messes with it.
-
Gary Courtney replied to the thread You Ham Fisted Nut !.You are correct. I had one but it must be out of calibration as the last saw I used it on was set for specs and snapped one off so I...
-
Use a 1/4 drive torque wrench next time and tighten to Stihl's specs.
-
Read all of the threads on software availability and it seems it is a divided camp. Two of the dealers in my city, one is John Deere and...
-
Gary Courtney reacted to singinwoodwackr's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
Not...yet :p -
Gary Courtney replied to the thread STIHL The Official Stihl Chainsaws Thread.Anyone have an aluminum case bolt snap?
-
-
Gary Courtney replied to the thread You Ham Fisted Nut !.I looked in my 5mm Sihl screws and could not find any steel screws. I sure hope if I have to take it back apartin the future they do...
-
Well ! I ran my 500i yesterday after a fresh build and I am really suprised. Was cleaning it up today and for some stupid thought I...
-
Gary Courtney replied to the thread SELLING Husqvarna 55 Rancher parts or project.@Olds120
-
Gary Courtney replied to the thread STIHL The Official Stihl Chainsaws Thread.
-
