Recent content by Fuddyduddy

Hunter cameras work well & not expensive. Set one up...don't mention saw much to anyone. Put another saw out hopefully catch the sob. Sent from my SM-S205DL using Tapatalk

Pour not poor. (#!%&# spellcheck) Sent from my SM-S205DL using Tapatalk

Nest, not best (spellcheck) Sent from my SM-S205DL using Tapatalk

In the evening when ground hornets are on best poor some gasoline in. Vapors go down killing them. Light it if you want to (I have[emoji2]). The big paper hornet nests my friend would wait til evening and close them up in an old suitcase leaving it on sidewalk in a bad part of town.[emoji38]...

I replaced with original bolts, but by retapping probably made that hole larger (bolt snapped off is/was harder than block material I bet). So I used a size larger self tapping screws and lockwashers...tight but didn't try lock tight. I'll make a bracket to hold it on, run it until it quits...

I did take it back to the dealer, but my experience is sure they can fix it, but most likely $300+, to me not worth it. I'll just fabricate a bracket holding muffler in place, use it until it quits. At that point if I can fix it myself $150 or less I'll do that, otherwise buy a different brand...

Bar. Stihl said it could be bent? Checks straight to me. Sent from my SM-S205DL using Tapatalk

It broke soon after I used it. Why I don't know. Sent from my SM-S205DL using Tapatalk

Just got off phone with Stihl after 28 minute wait. I haven't used it that much but they said DOP was 2/2015. I had to fix chain brake bar couple years ago, top housing screws fell out. They said vibration caused issue, usually bent bar or chain missing teeth(?). I have replaced bar once and...

I'll check. Thanks. Meanwhile I drilled the bolt broken side. New screws, tight...tight-tight! Muffler fell off AGAIN! After 5 minutes use. I finished cutting with no muffler, my hearing is shot anyway [emoji2955]. What's causing the blankety-blank muffler to fall off?!?!? Sent from my...

I just cut a fairly good sized dying white pine down, was limbing it when the muffler fell off my MS291. Can't figure out why. Soon as I got it in garage it's raining like crazy, so had to quit anyway. Getting the one bolt recessed will be fun. Any ideas...thanks in advance. Sent from my...

I ordered a kickback guard for a Sthil MS291 and got this. It's a little too tight, 4.5" from hole center to center. About 6" wide. No part numbers anywhere. Free if anyone can use it. Shipping shouldn't be much. Just send me a private message. Sent from my SM-S205DL using Tapatalk

Early on in post I was thinking she found someone else, but you're better than that. You'll find a nice lady. And what did Chris get?...a woman who runs around on her husband. Sent from my SM-S205DL using Tapatalk

Some fairly large ones sometimes, oak usually or locust. I heard carbide is the best, lasts longer, not that much more expensive. Sent from my SM-S205DL using Tapatalk

I have a Sthil MS291 and was thinking about putting a 24" bar & chain on it. Pros-cons? I've heard it will run slower? If so, I need to know gauge, pitch, # links? Otherwise I'll stay with 20", either way a carbide tip chain. Best one to get? Thanks. Sent from my SM-S205DL using Tapatalk