Thank you gentlemen. In the end, it probably is not my grandpa. Though that guy could be his twin. My grandpa was done working in the woods by 1970 and had opened up a saw shop, which finally closed in 2009. He passed away a few years later.
Sorry to resurrect such an old post... but:
When putting a HDA-199 on a 346, along with the 357/359 intake, air filter and spring clamp, do you also need to use the choke control, throttle rod, and kill control from the 357/359?
Was given a 2095 tonight. Locked up solid. Looks to be complete. It will be a couple of weeks before I have time to investigate why it’s locked up. Near new chain. 36” I think.
I only have one MM saw... a 346xp OE with a carb and intake from a 357xp. After about 5 tanks... it woke. It pretty much thinks its 70cc’s. It’s angry... and VERY anxious to work.
I have a 262xp I hope to have done. Not sure I’m up to it though!
I pulled the top end last night and started in on the cynlinder. At first look I thought it had damaged the plating, but after slowly working on it for an hour, it's looking pretty good. Still have to polish it up some. Before & After. I've ordered an AM piston and can't wait to get her running!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.