Recent content by firefighter

I did with the OEM cylinder block. I will with this one also.

I have no issue this far. I only have about a hour or 2 of time using it. It's far more useful then I thought. Figured id only use it for porting ect but use it alot. I think it is worth the 95 bucks Canadian I paid. I have dremels that were more that are chit compared to this. It has quite a...

Well fellas I ported the old thing. Very mild I think, exhaust is 100, blow down 22 and intake was 148 I believe. Notes are in the shop. Got all the air leaks looked after and running good. Made a small tiktok 🤣🤣🤣🤣 just after getting it ported and idling around...

Yes that a pretty good tip. I need some smaller round diamonds mine are a little big.

Gotcha that makes sense.

I haven't used in reverse yet. But it is nice and it's a torquie little bigger. And it's more affordable then the foredom sr. Can buy 4 for 1.

I just noticed in one of my earlier posts I said I didn't have the ability to raise transfer but I do. Lmao. 🤣🤣🤣🤣🤣🤣🤣 No kidding. It's scary how much I have spent in the past little while gathering supplies. You know anywhere else to buy attachments other then Amazon or eBay. I checked your...

I was checking them out on Amazon and have them in my cart. God love business discounts and the right offs. Once I have some disposable extras I'll grab one of your attachments. They look great compared the one I have gotten from China.

No worries I didn't think you were insulting, I'm learning so I take everything/shared info and learn from it. It is a replaceable shaft, it screws into the motor. It's the vevor sr hanging flex shaft. It's was 100 bucks Canadian vs 500 for a foredom. Figured I'd start cheap before expensive...

Thank you, I'm still learning this was a saw I had intentions of learning on. Ended up getting this saw for free cause of rebuilding and cleaning up the other one for him. So if I gets messed up I don't mind buying a piston and cylinder. I have a big bore kit but I was plagued with air leaks so...

Easy enough. I have some large nails I can convert easily enough.

I have vevor version of a foredom. I will put on my list of things to make tomorrow. Shouldn't be too hard to make a mandrel

I guess a little searching here and the other place I figured it out. Or well at least have an understanding.

Oh also should the transfers be smoother I know roughing intake for better atomization does that apply for the transfers also?

I don't have the ability to raise the transfers. I have the 90 degree attachment. I read lots about the widths and 65 was were I was aiming. Ironhorse not good info, typically watch the other like tinman, boady and Smitty but mostly read here.