FederalQ's latest activity
-
25 yr ago I was taking my first breaths. -
Happy New Year everyone!🎉 Last saw of the year... :)
-
AMC 360 cylinder heads. They were .003" warped. Used a granite surface plate and some 80 grit to surface them and now they're less...
-
Apparently I didn’t get 460 muffler cover but the 261 muffler came in today. It’s 109 grams heavier than the stock muffler. I didn’t get...
-
FederalQ reacted to oddsaws's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with
Like.
It’s the stock muffler with a 3/4 inch elbow brazed in place -
FederalQ reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
What kind of muffler is it on the 114? The front looks like US-spec but there is also a side pipe which seems to have stronger wall...
-
FederalQ reacted to oddsaws's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Getting closer to finishing my first Dolmar build, a 114. Shout out to @Shane¹ who has been most helpful getting me through this project 👍
-
FederalQ reacted to FATBOY2017's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
-
-
FederalQ replied to the thread Dominator oil.That’s where the high cost can be of benefit by safely extending the drain service intervals because internal combustion does not take...
-
Seems likely. But even then I'd be interested to know whether that was sales in terms of revenue or units sold. It's certainly...
-
FederalQ reacted to Funky sawman's post in the thread Random pics (that you took) thread... with Like.
You know times are rough when you have to break in a new old stock ms440
-
FederalQ reacted to stihl livin's post in the thread Random pics (that you took) thread... with Like.
We are still at least a dollar higher here.
-
FederalQ reacted to Only the Tony's post in the thread Random pics (that you took) thread... with Like.
-
not much, 19 would be pre epa. both will work fine on a stock saw. if your going to port it i would use a16 from a 460
