Recent content by Farmer_Nate

@Vintage Engine Repairs is also my favorite carb adjust vid.

Yes, an iterative solution back and forth works well also. What I was pointing out was that I never paid much attention to the location of the idle screw before. Now when finished tuning I try to have it just touching the butterfly cam or lever, then screwed a hair inward clockwise.

As I stated, the IPL on both saws quote the same OEM felling dogs. The dogs I make are slightly different shape, however. Mine fit the 500. I am going to need to actually put them onto a 462 to know for sure.

SS-DAWGS now available. Same as Ti-DAWGS except the material, which is 304 Stainless and more affordable. Thanks

Shown on 500i small clutch cover.

Found one! Thanks

I'd like a large clutch cover for 500i. 1142 640 1701

I think it is frowned upon to post commercial links here promoting one's website. The titanium products have a strange name... I think it rhymes with "Ti-DAWGS", or something like that. I think a search online will turn that up.

PM Sent

Very Very, extremely old post, but... I made some from titanium. I did that!

Old post but... I make a model of felling spikes for the 500i small clutch cover now. They are titanium. PM for more details or see the for chainsaw sale section under saw parts.

Commercial website is up now to facilitate purchase. PM if interested. or:

I'd bet the dogs would fit a 462 but I can't say until I get a real saw to try it on. Photos look real similar in the location called into question for the inner dog.

400 a sure no-go for the inner dog, though the outer will fit the clutch cover, so that doesn't seem a good option. The case on the 400 where the inner dog bolts is much different than 500i. 462 still possible, but not confirmed. Shop I visit sold their last 462 and they are on backorder for a...

Yes, the 400 is another candidate, but verification is in order. I plan to eyeball a 400 in a shop tomorrow to try to assess.