Fabulous's latest activity
-
I was always of the opinion that gutting the stratos was counterproductive and a hack move typical of the "doesnt take to porting"... -
They do suck the fuel down if they are gutted. Tree monkey kinda proved several years ago that if gutting the stratos helps, the...
-
Same applies to them if that's the case.
-
Fabulous replied to the thread Oil questions....I’m 99.9% certain Husqvarna uses a similar 200hr continuous wide-open throttle test on their chainsaws (55 minute on 5 minutes idle) …...
-
Fabulous replied to the thread Oil questions....Check out slide 11 - the results will surprise you. I cannot find the msds sheets for motomix - must be a “secret proprietary...
-
Fabulous replied to the thread Oil questions....https://www.slideserve.com/delano/stihl-inc-mix-oil-comparison
-
Fabulous replied to the thread treemonkey stuff.I’ve seen builds where the stratos ports were gutted / divider removed and yes I believe it would increase the output , however the fuel...
-
It would need to be in a spot that wouldn’t affect case compression on the way down and up. Like a finger or boost port
-
Fabulous replied to the thread treemonkey stuff.I’m referring to the power-stroke when the piston is being forced in a downward direction. I wonder IF a small hole or tunnel connecting...
-
-
Fabulous replied to the thread treemonkey stuff.Interesting … rather than use words a pic might show it better. If stock piston is used and the cylinder was dropped by “x” amount...
-
-
Fabulous reacted to EFSM's post in the thread The Great 2-stroke debate : Compression vs Flow with
Like.
This is what I was trying to articulate. -
Fabulous reacted to Loony661's post in the thread The Great 2-stroke debate : Compression vs Flow with Like.
I respectfully disagree about too much flow. Too much flow can cause the cylinder to over scavenge, therefore wasting fuel and becoming...
-
Fabulous replied to the thread WANTED Looking for a STIHL 064 builder saw..Ok - tell me what’s available thanks 😊
-
Fabulous reacted to Bill G's post in the thread WANTED Looking for a STIHL 064 builder saw. with Like.
I have some.
