Recent content by ErnieG

I have a 7300 and 372 both ported by Kris from S&S Worksaws ..I haven't ran the 7300 more then maybe a tank but I have ran the 372 a lot and I am very impressed by it . I can't really say anything yet about the 7300 till I get more run time with it but it does seem very close to the 372 so far ...

I'm open to a trade either running or a project Jonsered / Husky or Pioneer Thanks Ernie

Price drop to $150 plus the ride ... Thanks Ernie

More pics ...

Like to sell this Poulan Counter Vibe 3400 Saws very clean and looks lightly used Fired rite up and runs and oils good Comes with 20" 3/8 bar and oregon chain Saw still has the QC stamp lightly stamped on the bottom of the handle The only problem I see is a small piece broken on the clutch cover...

With the ignition there is a small bit of adjustment between the slots ...what would be the best place to set this ? Thanks Ernie I do see a small line on the side of the ignition but I don't see where it would be lined up with anything

Well I guess that makes sense 😂 Ernie

Working on a 123 and I have a question about the oil reservoir vent . Shows on the parts diagram just a small piece of twisted wire that goes in the hole in the reservoir...I can't see how this would be leak proof when the saw is tipped on the recoil side . Any other options with this ? Thanks...

Middle saws a Titan but I think the bar and chain your seeing is the 10-10 Ernie

Im looking for a muffler for a Sachs Dolmar 123 project? Let me know if you have one to sell Thanks Ernie

3/8 Thanks Ernie

3/8 Husqvarna branded would be good Thanks Ernie

Sent you a p.m Thanks Ernie

I appreciate the heads up but it's a bit more then I want to spend . Ernie

Looking for a 18" small husky mount bar ...let me know what you have ? Thanks very much Ernie