ErnieG's latest activity
-
ErnieG replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.Got a carburetor on the way to try ...I really hope it's that otherwise I don't know where to go after that ! Ernie -
ErnieG reacted to Wilhelm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with
Like.
You need the third version! 🤣 -
ErnieG replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.I have two different intakes and the same issue ...I don't think it's that's Thanks Ernie
-
ErnieG reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
The early 6100 had problems with the intake hose. I don't know if it may apply to you. The first intake hose version had number...
-
ErnieG replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.I can try that .. Brand new bulb and lines/filter Ernie
-
ErnieG reacted to Wilhelm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
I may still try run her WOT, short burst, without the muffler. Let her warm up with muffler on though. Use really good ear protection if...
-
ErnieG replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.Mufflers wide open ...I checked that a few times to be sure . Ernie
-
ErnieG reacted to Shane¹'s post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Worth checking for sure I had a 9000 through me for a loop with a plug muffler took me a bit to figure out that one
-
ErnieG reacted to Wilhelm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Muffler flowing free? Just a thought.
-
ErnieG reacted to Wilhelm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Flywheel should be fine as long as those gouges do not protrude. Still carb, just worn out at a bad place causing trouble? I can't...
-
ErnieG replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.I didn't swap the carb as I don't have a donor..I'm gonna have to find one somewhere! I'm definitely deep into this one but I'm not...
-
ErnieG replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.Back to the ea6100... I was able to source a entire block with good crank and got it all assembled but still having the same throttle...
-
-
I just put the new decals on my 670 yardsale find
-
No free saws in Croatia, no free anything really! Seller wants money for the molten carcass.
-
Those ones are worth the gamble if they're free.
