After the coil replacement it ran but still no decent idle.. eventually I found that the carb needle spring was worn, so it go too much fuel. I replaced it with a stiffer spring and it runs ok now.
Hello,
I have a 2013 T540XP that dies at full throttle, it shuts off. You can immediately start the saw after that. I checked the spark plug, fuel line, impuls line, intake boot, pressure tested the carb.
Any suggestions?
thx
Erik
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.