Piston is in decent shape. Has some wear as you can see in the pictures
Starts and runs but it defiantly needs a new fuel line and a carb kit.
Leaks gas where the line goes from the tank to the carb box.
Needs a good cleaning
PHO.
100.00 plus shipping
PayPal F&F
This one has an OEM cylinder with a Hyway piston. Pressure and vac tested and has no leaks. Approx 3-4 tanks since the piston was installed.
It’s missing the rubber grommet for the carb
Small chip on the side of the tank. See pics.
Asking 500.00 for the powerhead plus shipping.
I take PayPal.
This one has an aftermarket cylinder. I would assume it probably had an air leak and someone bought a cheap aftermarket top end for it. It does start and run but it needs to be checked out
Again. I bought a lot of saws over the last few weeks so I’m thinning them out.
Any questions contact me...
This one is beat up but runs fantastic. Someone put the bullhorn pipes on the muffler so it’s loud. Starter cover is cracked. I cut with it for about 15 minutes. Had no issues at all.
I’ve bought a lot of saws over the last few weeks so I’m thinning some out. Any questions send me a message...
Saw has a full wrap handle and WCS felling spikes.
On its 6-7 tank of fuel.
Just like new. No issues at all.
Asking 1500.00 plus shipping.
PHO for ease of shipping.
PayPal F&F please.
Dirty old saw that does run. I primed the carb with some mix to get it going. Made about 10-12 cuts with it. It smokes like an old saw. lol.
Going to need a good cleaning, carb kit, and probably fuel lines.
200.00 obo.
Powerhead only.
PayPal F&F please.
Saw looks to be in good shape. I got it with several others from a logger in Norman Indiana.
Tank has rust as shown in the pics
Compression felt weak but it fired up with mix poured into the carb. Ran for about 10 seconds and died.
Throttle is sticky.
Sold for parts or repair. Please ask...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.