EFSM's latest activity
-
EI dont mean it in it that way. Its the average cost of living in the US that has pushed the pay up. This in turn pushes up the cost...
-
EEFSM replied to the thread Concrete Cutting Saws.I really don’t know. But my parents later had this customer cut out a crawlspace access hole in a basement wall about 3’x3’ and he...
-
EThis is what you get for the money.
-
EEFSM replied to the thread Concrete Cutting Saws.Cool. I recently worked on one of these and noticed that the chain needs water even when test running it, at least on a dirty/used...
-
EEFSM replied to the thread WANTED 365sp top end, Crankshaft.Only have XT sorry.
-
EIt's the entire intake, fully assembled. Yeah, it's a bit spendy but, so is a new bottom and top end.
-
EI agree that it's a lot of money for a boot, Steve says it's a complete boot though. I look at it in comparison to a top end kit, and to...
-
EEFSM replied to the thread Husqvarna 592xp woes and fixes.Yep, I’d agree if the boot was actually cheap. I don’t consider 120 to be anywhere close to cheap for a piece of rubber.
-
EIf the primer bulb is weeping/leaking I would reread post #1 and #2. the check valve may have issues that may clear with fresh fuel...
-
ENew carburetors are cheap. Just make sure you do not get an aftermarket. It should have a Zama carb on it. And like someone else...
-
EIt is basically the same machine as an Echo TC 210.
-
EEFSM replied to the thread Firewood thread!!! Let's see what you got!!!!.To put it mildly, I don’t plan that far on ahead. Nothing wrong with it, but I haven’t matured that far yet, I guess.
-
E3 and 4:1, 1.5”, 2” glue lined… The cross hatch was the worst...absolutely junk.
-
EEFSM replied to the thread Stihl FC 56 C.I’m not understanding. You’re asking if the curved shaft edger can be changed to straight shaft?
-
EThe new Dike shop is probably getting full
