EFSM's latest activity
-
EEFSM replied to the thread WANTED 365sp top end, Crankshaft.I have a couple top ends. I’d have to dig them out to see what shape they’re in.
-
EEFSM replied to the thread Stihl MS311 vs Echo CS-590.I have had nothing but awful experiences with Neotec’s QC.
-
ENot pretty means less chance of it being stolen.
-
EEFSM replied to the thread Husqvarna 2100 thread.Excuse my ignorance, but what are they normally made from? EDIT I didn’t realize I wasn’t on the last page. Was the 2100 produced over...
-
EEFSM replied to the thread 1967 HOMKO tiller info.Briggs changed many of their engines over to a self contained magneto system that does away with the points. This model has a different...
-
-
EEFSM replied to the thread Stihl MS311 vs Echo CS-590.You can get a 620 for significantly less than 700.
-
EIt's got exhaust.
-
EWhen I read back the chat log later, I realized "oh *s-word, I am being interviewed by our future overlords, and they understand".
-
EEFSM replied to the thread Any Chinese chainsaw and chinese parts discussion.Let’s hope yours comes with the engine and shaft lined up properly.
-
EEFSM replied to the thread So what did you buy today.Sometimes the doctors are in a CYA mode, sometimes they really do mean it.
-
EAbsolutely terrible picture but I pulled this off of an Escalade at a scrapyard. 250 amp
-
ESomeone brought in a late model 70E for a good going over this week. I was reminded of the differences between the early and late...
-
EAs a bit of history going back when these saws were made, the only people at the time that could make a really good plating job on a...
-
EI appreciate the heads up but it's a bit more then I want to spend . Ernie
